RCFoam is no longer in operation.

This website is maintained as reference material and a reminder
of a time before tech monopolies ruined the internet
and coronavirus ruined everything else.
Depron and EPP Foam Suppliers, Carbon Fiber Sheets, Carbon Rods and Tubes, RC Model Airplane Engines, Lipo Batteries

Nitro: Repairing Pull Starts

Instructions on how to repair your pullstart.
1. Remove and Disassemble the pull start. 2. Begin the reassembly process by inserting the spring into spring slot in the housing. 3. Place the starter spool into the starter housing.
4. Wind up the spring. With one hand, hold the starter spool in place. With your free hand turn the starter housing counter clockwise. 5. Squeeze the end of the spring and insert into the starter housing. While still holding the spring tension with your left hand, insert the end of the starter string through the hole in the starter housing. Pull the string all the way through. 6. Slowly release the spring tension, allowing the string to "wind up". If the string is one or two inches from being tight, loosen the knit, cut off any excess slack and retie the knot securing the handle. If there is excessive slack, repeat steps 5 through 8, with an increase in the number of turns in step 5.
Copyright © The Xenon Project, LLC. Any duplication, copying, or use without prior written consent is illegal.

Log In

Note: you do not need an account to place an order!

RC Foam Biplane

electric rc trainer planes

remote control jet airplanes

Carbon Fiber Sheets, Carbon Rods and Tubes Suppliers

Contact Us

Foam Hobby Supplies

Valid HTML 4.01 Transitional

Positive SSL